Fuel Heater Temperature Sensor and Element Location 燃油加热器温度感知器和元件的位置
The Numerical Simulation Calculation for Tube Wall Temperature of Pedant Superheater of Power Station Boiler; Fuel Heater Temperature Sensor and Element Location 大型电站锅炉屏式过热器壁温数值模拟燃油加热器温度感知器和元件的位置
Temperature field finite element during flat hot continuous rolling process with compact double stand reversing rolling mill was researched, which is the only one in China. 实现了对国内唯一一架双机架紧凑式可逆炉卷轧机板材热连轧的温度场有限元研究。
Effects of Temperature and Alloy Element on Hot-dip Aluminizing Process for Decreasing Fe-Al film Thickness 不锈钢热浸镀铝中温度及合金元素对膜厚的影响
Below figure shows the relation between fumace temperatures, element temperature and element surface load under the condition that the element radiation isn't obstructed. 下图示出了元件辐射在不受阻碍情况下的炉温、件温度与表面负荷之间的关系。
Numerical computation of solid rocket motor insulation layer temperature by finite element method 固体火箭发动机绝热层温度场的有限元计算方法
Molten Quartz Optical Rod& A New Temperature Sensor Element 熔融石英光导棒&一种新颖的温度传感元件
PN node temperature sensor is used as temperature sensing element in PID temperature controller. It features high sensitivity, high accuracy, fast response and high resistance ability to interference. PID温控仪采用PN结温度传感器作为感温元件,它具有灵敏度高、精度高、响应快、抗干扰能力强等特点。
The change in strength of cryogenic austenitic steel with temperature and alloying element content was studied. 研究了低温奥氏体钢的强度随温度及合金元素含量的变化规律。
To Measure Instantaneous Temperature by a Finite Dimensional Temperature Sensitive Element 以有限尺寸的感温元件测取瞬态温度的方法
Hardware designs included the selection of temperature measuring methods and sensor, the studying of orientation mode of temperature measuring element, the selection and the introduction of temperature data logger and the development of transit equipment. 硬件设计包括测温方式与传感器的选择、测温元件定位方式的研究、温度巡回检测仪的选定和介绍以及巡检仪转接装置的研制等。
A wrist watch with temperature generating element 体温发电手表
Development on superhigh temperature heating element 超高温发热体(STH)的研制
Design of the tyre temperature finite element analysis system 轮胎温度场有限元分析系统的设计
S Electrothermal characteristics of a self-limited temperature heating pipe, a new self-limited temperature heating element for polymer composite that could be continuously produced was presented. 介绍了一种新型的可连续化批量生产的复合型高分子自限温发热元件&自限温发热管的电热特性。
A kind of three layered 32-node temperature shell element is presented for the transient temperature field FEM analysis of the honeycomb sandwich composite shell. 提出一种三层32结点温度壳单元,对蜂窝夹芯复合材料壳体的瞬态温度场进行了有限元分析。
Study of material for elevated temperature elastic element of deep-well-detector 超深井测井检波器高温弹性元件材料的研究
A copper-constantan thermocouple reference junction temperature compensator which is based on the compensating brige method and in which a thermistor is used as the temperature sensitive element is descr-ibed. 本文描述了一种利用桥路补偿法,采用热敏电阻作感温元件制成的铜&康铜热电偶参考端温度补偿器。
It adopts high precision and wide range thermocouple as temperature sensing element. This sensor has the characteristics of fast response speed, better capability, vibration and impact resistance, long working life, high product rate and produce in quantity. 该传感器采用测量范围宽的热电偶为感温元件,具有响应速度快、性能稳定、抗振动、耐冲击、工作寿命长、成品率高、适合于批量生产等特点。
The Research on the Temperature Sensing Element of the Thermostatic Valve 温控阀感温元件的特性研究
Using a more general equation of heat balance about the temperature sensitive element, the equation is obtained of instantaneous gas temperature and wall temperature in the case of the third boundary condition of heat transfer. 从感温元件热平衡更一般的表达式出发,导得了第三类边界条件中燃气的瞬态温度和壁面的瞬态温度的表达式。
The test results show that the micro temperature sensing element on PI film exhibits good linearity and a temperature coefficient of resistance is close to 0. 0023/ ℃. 实验测试结果表明,PI村底上的铂薄膜热敏电阻具备良好的线性度,其电阻温度系数接近于0.0023/℃。
The formula and method has an important direction for the design of temperature sensors that is using thermal resistant as measure temperature element. 对以热敏电阻作为测温元件的温度传感器的设计具有参考意义。
Study and application of a new type of high temperature double element delay crosslinking fracturing fluid 新型高温双元延迟交联压裂液的研究与应用
A measuring device for melting and crystallization parameters of slag has been developed using single thermal couple which not only is as a measuring temperature element, but also as a heating element with the characteristics of higher speed of temperature going up and lowering and higher measuring efficiency. 研制了热丝法炉渣熔化和结晶参数测定仪,该测定仪用一根双铂铑热电偶丝既作加热元件又作测温元件,具有升、降温速度快,测量效率高的特点。
In order to decrease the temperature grads, element balance method is presented in this paper to analyze the influence of some parameters on temperature grads of an air-cooling-plate-fin heat exchanger. 用元体平衡法对板翅式风冷换热器进行分析,从降低换热器的温度梯度入手,分析一些参数对温度梯度的影响情况。
Operating temperature of electrothermal element is estimated. 估算了电热元件的工作温度。
Temperature Fields Finite Element Analysis on the Twin Roll Strip Casting 双辊铸轧薄带钢温度场的有限元分析
The finite element model of the cable was simulated and calculated by ANSYS software, that verify the fact, if cable Transient conductor temperature could be calculated accurately by the cable temperature field finite element model or not. 利用ANSYS软件对电缆有限元模型进行仿真计算,验证电缆温度场有限元模型能否准确计算电缆暂态线芯温度。